COVID-19 Update - Clutch Engineering is open to support you.

Phone: 1-800-569-1291   Fax: 1-860-693-2197



The rotating seal is established by a non-metallic sealing ring, held against the rotorseal shaft by a light spring force. The sealing ring is designed so that media pressure acts on both of its ends to minimize the force on the sealing surface.

This design gives positive protection against leakage and compensates for seal wear. Ball bearings are used between the stationary and rotating ports to provide rigidity to the rotorseal assembly and to minimize the running torque.

Rotorseals are available with single, dual and triple passages, in a variety of sizes and designs, to provide the versatility needed to handle most requirements. Single passage rotorseals, in pneumatic installation, can be plumbed with a quick release valve at its inlet port to provide a convenient exhaust.

In most applications, the rotorseal is mounted to the end of a shaft. The shaft is rifle and cross drilled to provide a passageway for the media transmitted. It is important that the rotorseal’s axis of rotation be concentric with the rotating member’s axis of rotation to minimize rotorseal wobble.

To accommodate eccentricities, a flexible connection must be used between the rotorseal and supply. A rigid connection will tend to preload the rotorseal bearings. The flexible connection should not be installed taut and should include a union and 45º elbow.

The flexible connection should be attached to the rotorseal prior to fastening the rotorseal to the rotating body to avoid seal or bearing damage. The union connection to the supply line is made last.

For applications which demand a large flow, single passage rotorseal, the RH (rotating housing) type provides a solution. This design incorporates a mounting flange for attachment to the machinery shaft or assembly. External American National Pipe Threads are provided on the rotorseal inlet shaft to facilitate supply line connections.




Dimension D

3.19 in
81 mm

Dimension D1

2.00 in
51 mm

Dimension D4

2.000 in
50.8 mm

Dimension D48

0.22 in
6 mm

Dimension D54

0.41 in
10 mm

Dimension D55

0.25 in
6 mm

Dimension H

1.498 in
38.0 mm

Dimension H1

1.50 in
38 mm

Dimension M

0.41 in
10 mm

Dimension O

0.19 in
5 mm

Dimension O1


Dimension O3

0.16 in
4 mm

Dimension P

0.63 in
16 mm

Passage Area

0.019 in²
0.12 cm²


0.4 lb
0.2 kg

Maximum Speed

4000 rpm

Maximum Pressure

150 psi
10.4 bar

Hex Size

0.63 in
16 mm

Dimension A

1.596 in
40.5 mm